8
LIMITED WARRANTY
Geonaute guarantees the initial purchaser of this product that it is free
from any defects linked to material or manufacture for a period of two
years from the date of purchase.
Please keep your receipt as proof of
purchase. Read the manual carefully and keep it for the whole life-
time of the product.
- This warranty does not cover damage resulting from misuse, from a fai-
lure to respect the precautions for use nor from accidents; neither does
this warranty cover damage resulting from improper maintenance or
from use of the item for commercial purposes.
- This warranty does not cover damage resulting from repairs carried out
by persons not authorized by Geonaute.
- The guarantees contained herein explicitly replace all other guarantees
including the implicit guarantee of merchantability and/or suitability for
use. Geonaute cannot under any circumstances be held liable for any
damage, whether direct or indirect, general or specific, caused by or
related to these instructions for use or the products they describe.
- During the guarantee period, the item will either be repaired free of
charge by an authorized repair service or replaced free of charge
(depending on the distributor).
- The guarantee does not cover batteries or cracked or broken casings
where signs of a blow are evident.
PRECAUTIONS
Normal conditions of use
The chest belt must be positioned on the chest. If correctly placed, it
transmits information on the heart rate to the watch. Located in the recep-
tion cone (see diagram), the watch then displays the heart rate and offers
different items of additional information (target zone, intensity of exercise
etc.) to guide and optimize your fitness or training program.
Restriction on use
The chest belt does not incorporate coded transmission technology.
Interference may occur if you are too close to other heart rate monitor
users (about 1 meter).
INSTALLATION
The chest belt functions as a sensor and an emitter. It measures the dif-
ferences in potential created by the beating of your heart. It then sends
this information to the watch by radio signal. The quality and precision of
the measurement, as well as your comfort during your workout, depend
on the correct positioning of the belt. The sensors (A) are the black rub-
ber surfaces on either side of the central part.
Putting the chest belt on:
- Moisten the sensors with water or a water-based conducting gel to
ensure good contact
- Introduce one side of the elastic into one of the insertion holes (B) on
the belt.
- Attach the belt around the chest, then position the belt just below the
REAR
50 cm
50 cm
100 cm
50 cm
Belt
FRONT
EN
