12
3.5 Example Setup Using Text Commands
For 8002-1-1 and 8002-1-2:
Route the vibrating wire transducer cable into the LC-2 enclosure
through the SENSOR bulkhead fitting. Connect the cable wires to the datalogger’s 5-pin internal
terminal block, located on the battery pack mounting plate. (Refer to Section 3.1 or Appendix B,
for wiring information.)
For 8002-1A-1 and 8002-1A-2:
Connect the vibrating wire transducer cable to the SENSOR
connector on the LC-2 enclosure.
For USB connected LC-2 dataloggers (8002-1-2, 8002-1A-2), it is important that the LC-2 first
be connected to the computers USB port before running LogView (or other communications
program) so that the LC-2 can be recognized by the computer as a virtual COM port.
Proceed with the following steps to connect with the datalogger using a terminal emulator
program such as Microsoft Windows HyperTerminal™:
1)
Launch HyperTerminal (
Start → All Programs → Accessories → Communications →
HyperTerminal
). If running under Vista or newer, contact Geokon for Geokon’s Terminal Window
Software.
2)
Enter a name for the New Connection and click OK (see Figure 14):
Figure 14 - HyperTerminal Connection Description
