2
3. INSTALLATION
The recommended method of installation involves attaching the enclosure (MICRO-800) to a
fixed structure, such as a wall, in an upright position (Figure 1). Mounting dimensions shown in
inches:
Figure 1 - Dimensions
3.1 Turning on Power
After the Datalogger is installed the charger can be plugged into the AC mains and the On/Off
switch S1 on the Charge Regulation circuit board switched to the “On” position (Figure 2). It is
recommended that the charger be left plugged in at all times (Section 5.1).
Figure 2 - Charge Regulation Circuit Board
