Step 5 – Confirming connection
1.
On the Display, the should now be on (this could take up to
two minutes), otherwise please refer to the troubleshooting
section. The shows that the Display is communicating with
the Transmitter.
2.
Remove the batteries from the Display and plug the power
supply provided.
Congratulations, the display is successfully set up and ready
to use.
Step 1 – Display
1.
During the setup place four batteries in the back of the Display.
2. When turned on the Solo PV displays its software version, then the
‘card in’ screen (if applicable) followed by the main screen.
3.
Hold the middle (set) button in for 3-4 seconds until ‘set year’ is
displayed. To change the year use the left and right buttons. For
further information on settings refer to the user manual.
What’s in the box?
2
1
Step 2 – Transmitter
1.
Open the unit by pressing the button and pulling the outer
cover away from the bottom.
2.
Remove the battery tab from the Transmitter.
3.
The green light will flash to show that the batteries
are working.
Step 3 – LED reader placement
1.
Find the pulse output on the meter.
2.
Stick the velcro circle over the pulse output on the meter.
3. Place the LED reader over the velcro circle on the meter,
please make sure that the GEO logo is facing you.
1
2
3
Step 4 – LED reader & Transmitter
1.
Ensure the LED reader is firmly connected to the
Transmitter. Sometimes requiring a second push to make
good connection.
MAC : 00 00BC00 0B0 1 0 DA0
SN : 000000000 000 00
TRANSMITTER
SOLO PV DISPLAY
DISPLAY POWER SUPPLY
LED READER
AA BATTERIES
DISPLAY STAND
SD CARD
2
3
2
4 x 1.5V AA CELLS
www.greenenergyoptions.co.uk
1
3
1
