STEP 7:
Attach the fold flat hood to the mirror frame using the 2 plastic thumb
screws (arrowed below) on each side of the mirror frame, 4 screws in
total, again these need only be finger tight. The sliding camera baffle
should be inserted into the guides on the back of the hood prior to
securing the hood to the frame. The neoprene rubber donut faces the
rear of the rig.
STEP 8:
Insert the small brass mirror tilt adjuster screw into the hole at the top
of the mirror frame. If the threaded hole for this screw is on the inside of
the mirror box, then you have installed the mirror assembly the wrong
way around. In this case return to step 6 and install the mirror frame
the other way around. Never over tighten this screw, it should only ever
be gently screwed in with light finger pressure.
