65
6--
6WLYH[PVU JVU[»K
:[HY[PUN
:[VWWPUN,UNPUL
6WLYH[L[OL9LJVPS:[HY[!
7\SS[OLZ[HY[LYNYPWSPNO[S`\U[PS`V\MLLSYLZPZ[HUJL
[OLUW\SSIYPZRS`9L[\YU[OLZ[HY[LYNYPWNLU[S`
7\SSPUN[OLZ[HY[LYNYPWVWLYH[LZ[OLYLJVPSZ[HY[[V
JYHUR[OLLUNPUL
6WLYH[L[OL,SLJ[YPJZ[HY[!
7\ZOHUKOVSK[OLLUNPULZ^P[JOVU[OL¸:;(9;¹
WVZP[PVUMVYeZHUKJYHUR[OLLUNPUL
0M[OLJOVRLOHZILLUTV]LK[V[OL¸:[HY[¹WVZP[PVU
[VZ[HY[[OLLUNPULNYHK\HSS`TV]LP[[V[OL¸9<5¹
WVZP[PVUHZ[OLLUNPUL^HYTZ\W
;\YU[OLLUNPULZ^P[JO[V[OL¸:;67¹WVZP[PVU
;\YU[OLM\LS]HS]LSL]LY[V[OL¸6--¹WVZP[PVU
>OLU[OLLUNPULPZUV[PU\ZLSLH]L[OLM\LS]HS]LPU
[OL¸6--¹WVZP[PVU[VWYL]LU[JHYI\YL[VYMSVVKPUN
HUK[VYLK\JL[OLWVZZPIPSP[`VMM\LSSLHRHNL
:[HY[LY.YPW
¸9\U¹7VZP[PVU
6^ULY»Z 4HU\HS
:;67
20
Operation (cont’d)
Powering 120 Volt AC Tools And Equipment:
1. Prior to powering tools and equipment, make sure the generator’s rated voltage, and amperage
capacity (120 V AC @ 66.7 AMPs) is adequate to supply all electrical loads that the unit will
power. If powering exceeds the generator’s capacity, it may be necessary to group one or more
of the tools and/or equipment for connection to a separate generator.
CAUTION: ATTEMPTING TO POWER SENSITIVE ELECTRONIC EQUIPMENT
WITHOUT THE USE OF AN APPROVED LINE CONDITIONER MAY CAUSE
DAMAGE TO THE EQUIPMENT. GENTRON/UPC PRODUCTS ARE NOT
RESPONSIBLE FOR ANY DIRECT OR INDIRECT DAMAGE CAUSED BY FAILURE
TO USE AN APPROVED LINE CONDITIONER.
2. Once the generator is running, simply connect the power cords of 120 volt AC powered
tools and equipment into the 120 volt AC dual outlets.
NOTE: THE GENERATOR FEATURES AN AC NON-FUSE THERMAL PROTECTOR
TO PROTECT THE AC CIRCUIT IN CASE OF AN OVERLOAD. SHOULD
AN OVERLOAD OCCUR, THE BREAKER WILL POP.
3. Disconnect all electrical powered tools and equipment from the generator’s 120 volt AC
duel outlets.
4. After the engine and generator have completely cooled, store generator in a safe, clean, dry
location (if not already installed).
10000W Generator
