Note:
Some devices may require you to replace this Programming Step 2 with procedures
noted in the “Gate Operator / Canadian Programming” section. If the HomeLink indicator
light does not change to a rapidly blinking light after performing these steps, contact
HomeLink at
www.homelink.com
.
3. Firmly
press, hold for five seconds and release
the programmed HomeLink button up to
two separate times to activate the door. If the door does not activate, press and hold the just-
trained HomeLink button and observe the indicator light.
•
If the indicator light
stays on constantly
,
programming is complete
and your
device should activate when the HomeLink button is pressed and released.
•
If the indicator light blinks
rapidly for two seconds and then turns to a constant
light continue with “Programming” steps 4-6
to complete the programming of a
rolling code equipped device (most commonly a garage door opener).
4. At the garage door opener receiver (motor-head unit) in the garage, locate the “learn” or
“smart” button. This can
usually
be found where the hanging antenna wire is attached to the
motor-head unit.
5. Firmly press and release the “learn” or “smart” button. (The name and color of the button
may vary by manufacturer.) There are 30 seconds to initiate step 6.
6. Return to the vehicle and firmly
press, hold for two seconds and release
the programmed
HomeLink button. Repeat the
“press/hold/release”
sequence a second time, and,
depending on the brand of the garage door opener (or other rolling code equipped device),
repeat this sequence a third time to complete the programming process.
HomeLink should now activate your rolling code equipped device.
