Page: 7 of 16
Copyright © 2013 GenTent Safety Canopies, LLC – All Rights Reserved
V5 – July, 2013
Install GenTent Clamps on Generator Frame
1)
Determine whether the Rubber Sleeve and/or Rubber Pads are
required
Your GenTent Clamp kit includes 4 rubber sleeve adapters and 8 sticky backed rubber
pads. Depending on the diameter, you will use one or both of these with your clamps.
Please see the following matrix:
A (1 inch)
B (1.25 inches) C (1.5 inches)
Rubber Pads
Yes
No
Yes
Rubber Sleeve
Yes
Yes
No
If you do not know the diameter of your frame tubes, simply cut out the Frame
Diameter tool below and wrap it around the frame tube from right to left. As shown
below, the arrow will point to A, B, or C, which correspond with the letters above.
Simply match the letter and follow the recommendations for pads and/or sleeve.
