Page
4
of
7
5.
Power supply in Setting State now.
Press “RUN/STOP” button, it will enter into Operating State.
EDIT [ 0 ]
RUN!
00:01
U = 100V
▶
100v
I = 500mA
350mA
P = 300W
35w
6.
Power supply in Operating State now.
Press “RUN/STOP” button,
it will stop output and return
to Setting State.
7.
In Setting State, continue to press “EDIT” button, it
will enter into Editing State and display:
“SAVE [□]” → “LOAD [□]” → “T= □□:□□” → “QUIT” → “SAVE [□]”…
EDIT [ 0 ]
U = 100V
0v
I = 500mA
0mA
P = 300W
0w
8.
At “SAVE □”, press “
▲
”
or “
▼
”
button to select number of memory program. The range of
number is from 1 to 9. Then press “ENT
”
button to save current method into this program.
9.
At “LOAD [□]”, press “
▲
”
or “
▼
”
button to select number that needed. The range of number is
from 1 to 9. Then press “ENT
”
button to load the current method from program.
10.
At “T= □□:□□”, press “
▲
”
or “
▼
”
button to set operating time.
11.
The range of timer is from 1min to 99hs and 59mins. Then press “ENT” button to save
it.
EDIT [ 0 ]
U = 100V
0v
I = 500mA
0mA
P = 300W
0w
12.
At “QUIT”, press “ENT” button to quit Editing
state, and return to Setting State.
ERROR ALARM
1.
When the power supply run with Over-load, it will stop automatically and alarm with buzzer,
then display
“ERROR 1!”.Turn off the switch
immediately.
2.
When the power supply run with No-load, It will stop automatically and alarm with buzzer, then
display
“ERROR 2!”.Turn off the switch
immediately.
