18/03/2013 Genlab Ltd
OP INS PRIME RANGE Issue 1
Page 2 of 6
OPERATION – Standard Control (cont)
3.11 The ‘yellow running LED’ will illuminate to show the oven is on, the ‘temperature display’ will
show the current oven temperature, and the ‘setpoint display’ will continue to show the
selected setpoint.
3.12 When the ‘Temperature display’ has reached the ‘setpoint display’ you can turn down the
Overheat dial until the ‘Red Alarm LED’ comes on and an ‘Er1’ error message is displayed.
Then turn the Overheat dial back up a small amount and press the Overheat reset button to
energise the circuit again.
NOTE:
If the Red Alarm LED won`t go out when Overheat Reset is pressed then turn the
Overheat dial up slightly more and retry the Overheat Reset button.
OPERATION – Timer Mode
3.13 Position the shelves within the work chamber.
3.14 Switch ‘ON’ the mains switch, indicated by lighting up green.
3.15 If the unit is already in use press the ‘start/stop button ’ to extinguish the amber lamp.
3.16 Set the target temperature as standard mode but do not press the start/stop button.
3.17 Press and hold the ‘timer button ’ for 2 seconds.
3.18 The ‘setpoint display’ will change to show the time the oven will stay on for in minutes. The
temperature display will show “t” to indicate the time is being adjusted.
3.19 Use the increment and decrement buttons
to set the desired time. The time is set
in 5 minute steps up to 8 hours followed by 1 hour steps up to a maximum 99 hours.
3.20 When no keys have been pressed for 10 seconds, or if the `timer button ’ is pressed
again, the new value will be stored and the temperature display will return to normal.
3.21 Set the ‘overheat dial’ to approximately 10 to 15 degrees above your target setpoint.
3.22 Press the ‘Overheat reset’ button to energise the overheat circuit.
3.23 Press the ‘timer button ’ The oven will heat up to your target setpoint.
3.24 The ‘yellow running LED’ will flash to show the oven is in timer mode
3.25 When the set point has been reached the timer will start to time down.
3.26 Whe the timer expires the heat will turn off and the the ‘yellow running LED’ will go out.
3.27 The ‘temperature display’ will show the current oven temperature, and the ‘setpoint display’
will show time remaining.
3.28 The timer will automatically pause if the oven temperature falls more than 5 degrees below
the set point and will remain in pause mode until it is within 1 degree of the setpoint. To
indicate this feature, the timer display will flash the time remaining.
