18/03/2013 Genlab Ltd
OP INS PRIME RANGE Issue 1
Page 1 of 6
Tanhouse Lane, Riverview Industrial Estate
Widnes, Cheshire WA8 0SR England
Tel: 0151 424 5001
Fax: 0151 495 2197
Web site: wwww.genlab.co.uk
E-mail:
_______________________________________________________________________
OPERATING INSTRUCTIONS FOR PRIME RANGE
1.
UNPACKING
1.1
Remove all packing material from between the shelves and inner walls of the oven.
2.
MAINS SUPPLY
2.1
240-volt units.
Each unit comes supplied with a mains connection lead already fitted with
a correctly rated fuse. The fuse rating and other details for each unit is shown on the
voltage plate riveted to the back of the unit. It is important that, if the fuse needs to be
replaced, it must only be replaced with one of the correct rating.
2.2
110-volt units
are supplied with a cable but without a plug or fuse. These units should be
wired in by a suitably qualified electrician to the following:-
BROWN
‘L’ Live pin
Refer to voltage plate
BLUE
‘N’ Neutral pin
for fuse requirement
GREEN/YELLOW ‘E’ Earth pin
WARNING
DO NOT CONNECT THE OVEN TO A D.C. MAINS SUPPLY OR
SERIOUS DAMAGE WILL OCCUR
3.
OPERATION – Standard Control
3.1 Position the shelves within the work chamber.
3.2 Switch ‘ON’ the mains switch, indicated by lighting up green.
3.3 If unit is already in use press the ‘start/stop button ’ to extinguish the amber lamp.
3.5 Press and hold the ‘temperature button ’ for 2 seconds.
3.5 The ‘setpoint display’ will continue to show the setpoint as it is edited. The ‘temperature’
display will show “S” to indicate the setpoint is being edited.
3.6 Use the increment and decrement buttons to set the desired temperature in one
degree steps.
3.7 When no keys have been pressed for 10 seconds, or if the `temperature button ’ is
pressed again, the new value will be stored and the temperature display will return to normal.
3.8 Set the ‘overheat dial’ to approximately 10 to 15 degrees above your set point. Refer
to Page 6 for Overheat Scaling.
3.9 Press the ‘Overheat reset’ button to energise the overheat circuit
3.10 Press the ‘start/stop button ’
