English
-3-
ID Channel Setting
The channel ID is factory preset. The green LED (data transmission
indicator) will be lit constantly when the wireless device is in normal
operation. In case your wireless devices do not work, please reset the
ID channel by:
1. Press the connect button on the receiver and the LED will be
blinking for connection.
2. Press the connect button of the wireless device once within 20
seconds and observe if the LED light on the receiver has gone off.
If yes, it means the wireless device is ready for use.
Warning (Trouble shooting)
1. In case the wireless device was not connected when you set the ID
channel setting, check if you have installed the batteries with the
positive (+) and negative (-) polarity in the correct position, then
repeat the ID channel setting again.
2. For optimum performance, please make sure that the distance
between the wireless device and the dongle receiver does not
exceed 10M.
Cleaning on keyboard’s solar device
1. To clean the solar bezel, please use only silk or cotton materials
and gently wipe this area.