SIERRA 800
I N S TA L L AT I O N I N S T R U C T I O N S
P A G E 9
SURFACE INSTALLATION
J
L
B
B
N
P
N
P
L
LEFT
RIGHT
C
I
O
B
F
4A
4B
6
4C
Windy conditions may affect the performance of a retractable screen. Retract the
screen in windy circumstances, during inclement weather, when not needed to
support immediate ventilation or during prolong periods when not used.
FOOT RELEASE LEVER
The
I-Foot Release Lever
is an optional feature that makes it easier to slightly
rotate the
C-Pull Bar
in order to disengage the
J-Pull Bar Locks
[Fig FIG 4C]
without bending over. Before installing, position the
I-Foot Release Lever
16" to
20" from the end of the
C-Pull Bar
on the side closest to the
Operating Wand.
Attach the
I-Foot Release Lever
to the
C-Pull Bar
using two
O-#6 x 3/8” (9mm)
Phillips Panhead Screws.
INSTALLING SIDE RAILS
Install the
J-Pull Bar Locks
at the bottom of each
B-Inside Rail
. Be sure that
the
J-Pull Bar Lock
can engage the
C-Pull Bar
as shown in image [Fig 4C]. Slide
B-Inside Rails
onto the tabs protruding from the
E and F-Cassette End Caps
, with
the shorter pile to the inside [Fig 4D]. Use an 1/8” drill bit and first drill through both
sides of the
B-Inside Rails
where they are to be fastened. Next, using a 3/8” bit, drill
through the outside face only. This will allow you to snap the
L-Screw Cover Caps
in
place. Square and attach
B-Inside Rails
with
N-#8 x 3/4” (19mm) Phillips Pan-
head Screws
. Install
L-Screen Cover Caps
into each hole in the
B-Inside Rails.
Using the height adjustment wheels on the
J-Pull Bar Locks
, adjust the height
to the appropriate level so they easily engage the
C-Pull Bar
. When correctly
adjusted the latching and unlatching should be smooth and easy.
Shorter Pile
4D
See page 10 for Operating Wand Instructions.
INSTALL THE TENSION DEVICE
Go to page 10.