Frame 3
Installing KidsBall
Follow these steps to install KidsBall.
Important: Remember to turn off your computer before installing KidsBall.
1.
Connect KidsBall to your computer. Plug the 9-pin connector into an available serial port.
2.
Turn on your computer. KidsBall will work once you have installed the driver.
Using KidsBall with Another Mouse
KidsBall can work with another mouse device on the same computer. For example, you can connect a mouse on COM1
and KidsBall on COM2. This allows you and your child to learn or play together.
Installing the Driver
Before you install the driver, make a copy of the original diskette and make sure you have connected KidsBall to your
computer. Installing the diskette only takes a couple of minutes and is quite easy.
Follow one of the installation procedures by the application you are using on your computer.
If You Are Using Windows 95 Plug and Play
The following steps allow you to install KidsBall with an existing mouse or alone.
1.
Turn on your computer and Windows 95 will start. Insert the driver diskette into drive A (or B).
2.
After you have started Windows 95, if the
“New Hardware Found”
panel appears, we suggest you select
“cancel”
and
follow the instructions below to install the driver. If you just want to install the driver only, select the second item
“Driver
from disk provided by hardware manufacturer”
, then type A:\ (or B:\) and
OK
to install the driver.
3.
Select
Run
under the
Start
button. Type
A:\SETUP
(or
B:\SETUP
) and click OK. Follow the instructions as they appear
on the screen.
Note: If you only connect KidsBall without using a mouse, then press
“Ctrl-ESC”
on the keyboard for
“Start”
and
select
“Run”
.
●
kd-896
file:///D|/KidsBall/html/kd-896.htm (2 of 7) [10/12/1999 10:37:50 AM]
