FCC Notices
FCC Compliance
This equipment complies with Part 68 of the FCC Rules. On this equipment is a label that contains,
among other information, the FCC registration number and Ringer Equivalence Number (REN) for
this equipment. You must upon request, provide this information to your telephone company.
If your telephone equipment causes harm to the telephone network, the Telephone Company may
discontinue your service temporarily. If possible, they will notify you in advance. But, if advance
notice is not practical, you will be notified as soon as possible. You will be informed of your right to
file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations, or procedures that
could affect proper operation of your equipment. If they do, you will be notified in advance to give you
an opportunity to maintain uninterrupted telephone service.
The FCC prohibits this equipment to be connected to party lines or coin-telephone service.
In the event that this equipment should fail to operate properly, disconnect the equipment from the
phone line to determine if it is causing the problem. If the problem is with the equipment, discontinue
use and contact your dealer or vendor.
The FCC also requires the transmitter of a FAX transmission be properly identified (FCC Rules Part
68, Sec. 68.381 (c) (3))
FCC Class B Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
i
Reorient or relocate the receiving antenna
i
Increase the separation between the equipment and the receiver
i
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
i
Consult a dealer or an experienced radio / TV technician for help
Notice:1) Shielded cables must be used in order to comply with the emission limits. 2) Any change or
modification not expressly approved by the manufacturer of this equipment could void the user form
operating this equipment.
CTR-21 Notices
