Quick Start Guide
4 Channel Long Range Wiegand Radio Receiver - Up to 60m
6
1.11 Antenna Switch
As shipped, the Receiver’s Antenna Switch is set in the INT (internal) position. Read range
can be extended using a separate, external antenna attached to Receiver’s on-board 6.19
mm SMA jack connector. If a separate, external antenna is used, then the switch should be
set in the EXT (external) position. For installations requiring a separate, external antenna,
please refer to the WRR-4 External Antenna Reference Document.
1.12 Beeper Switch
As shipped, the Receiver’s Beeper Switch is set in the ON position. If the installation
technician prefers to disable the beeper and External LED Indicator, then the Beeper Switch
should be set in the OFF position.
1.13 10-Pin Terminal Block
Refer to the information below for cabling to the Receiver:
AD0: Button One, Wiegand Data 0, Channel A.
AD1: Button One, Wiegand Data 1, Channel A.
BD0: Button Two, Wiegand Data 0, Channel B.
BD1: Button Two, Wiegand Data 1, Channel B.
CD0: Button Three, Wiegand Data 0, Channel C.
CD1: Button Three, Wiegand Data 1, Channel C.
DD0: Button Four, Wiegand Data 0, Channel D.
DD1: Button Four, Wiegand Data 1, Channel D.
GND: Power, 0VDC (Ground).
+VDC: Power, 12VDC Nominal.
NOTE: Apply positive voltage only to the +VDC Pin on the Terminal Block.
1.14 Connection
Connection must be done in accordance with NFPA 70. Do not connect to a receptacle
controlled by a switch. Connect to a power limited DC voltage source.
1.13 Troubleshooting
No data received/Transmitter not enrolled
Transmitter must be clicked twice to be learned by the Receiver upon initial Receiver
power up
