LED lights, Green light after the power supply has been in a state of slow flash, the red
light is used for remote learning and remote control when the state of the instructions,
OFF state under normal condition;
2
、
Picture6 (Genie receiver box B)
：；
Receiving frequency is dual frequency of 390MHZ,
LED is
monochrome LED
lights, is used for remote learning and remote control when
the state of the instructions, OFF state under normal condition;
3
、
Both receiver box access Power supply: DC 12V-24V
二）
、
Steps learning remote codes
：
1
、
Press the learning button on the receiver and then release, the red LED on the
receiver box will flash 2 times per second;
2
、
Press the button you want to learn with receiver within 30 seconds, you will see the red
LED on the receiver then keep lighting;
3
、
Within 30 seconds press again the same button you want to learn with receiver , the
red LED will go out, then the end of the study;
三）
、
The control state of Receiver
When press the remote button we’ve learned, the red LED will lighting about 1S and
then flashing; When press the remote control button is no learning or learning
unsuccessful, the red LED will keep blinking;
四）
、
Removed the remote code that receiver has recorded
Press the learn button of receiver until the red LED on the receiver go out, then deleted
successfully;
Please Note: Each remote control has only one valid button to control the receiver,
that is, if you learn all the keys of the remote control into the receiver, then only the
last significant study supporting the receiver and remote control key to be able to
work.