Genie Nano-CL C2450, User Manual

Page: 30 / 118

28
•
Nano-CL Installation Genie Nano-CL Series™
The Camera Works — Now What
Consult this manual for detailed Nano-CL feature descriptions, as you write, debug and optimize
your imaging application. Consult the frame grabber manual for all board control features.
Nano-CL Connectors and Status LED Overview
Connectors
The Nano-CL has three connectors:
•
A 10 pin I/O connector for camera power, plus trigger, strobe and general I/O signals. The
connector supports a retention latch, while alternately the Nano-CL case supports using an I/O
cable with thumbscrews. Teledyne DALSA provides optional cables for purchase (see
Accessories). Also see 10-pin I/O Connector Details for pin out specifications.
•
Two standard miniature SDR-26 Camera Link connectors. Use a frame grabber with SDR-26
connectors to simplify cabling. See Components Express Contact Information for a wide variety
of PoCL cables.
• Note that these three connectors are identical on the two physical case sizes of the Nano-CL
series.
The following figure of the Genie Nano-CL back end shows connector and LED locations. See
Mechanical Specifications — Nano-CL: for details on the connectors and camera mounting
dimensions.
Status LED
I/O
Connector
Genie Nano-CL (medium casing) – Rear View