Genie GS-2032, Service Manual

Page: 79 / 236

Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246 4 - 39
June 2003 Section 4 • Repair Procedures
REV A
73 Remove the pin retaining fasteners from the
lower lift cylinder barrel-end pivot pin (index
#29). Use a soft metal drift to remove the pin.
Remove the cylinder from the machine.
Crushing hazard. The cylinder
may become unbalanced and fall
when it is removed from the
machine if it is not properly
attached to the overhead crane.
Component damage hazard. Be
careful not to damage the valve or
fittings on the cylinder while
removing it from the machine.
74 Support and secure the entry ladder to an
appropriate lifting device.
75 Remove the entry ladder mounting fasteners.
Remove the entry ladder from the machine.
Crushing hazard. The entry ladder
may become unbalanced and fall
if not properly supported and
secured to the lifting device.
76 Remove the cables from the number 1 inner
arm (index #14) and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
77 Attach a lifting strap from an overhead crane to
the number 1 outer arm (index #30). Do not
lift it.
78 Remove the external snap rings from the
number 1 center pivot pin (index #13).
79 Use a soft metal drift to remove the number 1
center pivot pin (index #13).
Crushing hazard. The number 1
outer arm (index #30) may
become unbalanced and fall if not
properly supported when the pin is
removed.
80 Slide the number 1 outer arm (index #30) to the
non-steer end and remove it from the machine.
Crushing hazard. The number 1
outer arm (index #30) may
become unbalanced and fall if not
properly supported when removing
it from the machine.
Note the position of the wear pads
before the arm is removed so
when the scissor is assembled
they will be in the correct position.
81 Attach a lifting strap from an overhead crane to
the number 1 inner arm (index #14).
Do not lift it.
82 Remove the pin retaining fasteners from both of
the number 1 pivot pins (index #15). Use a slide
hammer to remove the pins.
83 Remove the number 1 inner arm (index #14)
from the machine.
Crushing hazard. The number 1
inner arm (index #14) may
become unbalanced and fall if not
properly supported when removed
from the machine.
SCISSOR COMPONENTS