Genie Aladdin Connect, Installation Manual, Page: 14 / 24

12
w
w
w
.G
enieC
ompan
y.c
om
Mount Aladdin Connect™.
NOTE: The powerpack cord is 5 feet long, mount
Aladdin Connect® within reach to a power outlet.
1. Remove mounting bracket from the back of
DCM.
2. Mark and drill 3/32” pilot holes and mount
bracket to wall using supplied screws. If
mounting to drywall, drill 3/16” pilot holes and
use anchors provided in kit. FIG. A
3. Route wall control wires from Aladdin
Connect™ as shown through the top or
bottom to suit your installation.
4. Strip 1/4” of insulation from wire and press the
orange tab and install wire into plug. FIG. B
5. Plug PowerPack cable into Aladdin Connect™
and route cable through slot (top or bottom)
6. Snap Aladdin Connect™ to mounting bracket.
FIG. C
7. Plug PowerPack into wall outlet.
FIG. A
FIG. B
FIG. C
DCM Mounting
Screws
DCM Mounting Screw
Anchors (as needed)