Genie Hand TDS Series, Operating Instructions Manual

Page: 7 / 44

Extraordinary maintenance
Extraordinary maintenance is required in cases of breakdowns or breakages due to heavy exploita-
tion, unpredictable accidents or improper use of the device.
The situations that can be created from time to time are completely unpredictable and therefore it is
not possible to describe appropriate intervention procedures.
If necessary, consult the technical service to receive instructions appropriate to the situation.
All interventions, mechanical or electrical, ordinary or extraordinary, must in any case be carried out
by specialized personnel.
The environmental policy of Genie Hand S.R.L. limits the use of polluting materials (lead, solvents,
etc.) to the minimum necessary. According to current Community legislation, it is necessary to dis-
pose of the safe in accordance with the local regulations regarding the disposal of mechanical, elec-
trical and electronic waste. For no reason abandon the product in the environment: this action can
be prosecuted as a source of long-term pollution.
In case of further doubts about disposal, contact Genie Hand S.R.L.
In order to avoid the risk of electric shock and / or injuries, the instructions in the manual and in the
following notes must be followed carefully.
• Do not open the container for any reason. Removing the cover or disassembling any other panel
will cause the operator to be exposed to potentially dangerous voltages. For interventions inside,
contact only Genie Hand S.R.L. and to technical personnel.
• Do not expose the apparatus to rain, splashes of water, excessive humidity, steam, dust, metallic
particles or any other material that may penetrate inside.
• Do not expose the appliance to heat sources.
• At the time of installation or use in hot and humid rooms as a result of storage or transport at very
low temperatures, condensation can form on the outside and inside the equipment. It is therefore
essential to wait for this condensation to disappear before activating the electrical part.
• Always use standard and intact power cables.
• Always check that the power supply network complies with the indications in the technical speci-
fications of the equipment.
Disposal
Construction materials of the device do not require special disposal procedures. In case of demo-
lition, refer to the local regulations for the scrapping of electrical and electronic equipment.
Never disperse the product in the environment.
NOTE
THE MANUFACTURER IS NOT IN ANY WAY RESPONSIBLE FOR DAMAGES CAUSED BY THE DEVICE
WHICH IS NOT USED IN THE INTEGRAL VERSION AND FOR USES AND THE METHOD OF USE SPECIFIED
IN THIS MANUAL. THE MANUFACTURER IS NOT IN ANY WAY RESPONSIBLE FOR ANY DAMAGE TO PERSONS
OR THINGS ARISING FROM THE RECOVERY OF PARTS OF THE DEVICE USED AFTER ITS DISMANTLING.
7
CAUTION
IN ORDER TO DO NOT INCREASE IN RISK OF ELECTRIC SHOCK AND / OR
WOUNDS IS NECESSARY
FOLLOW THE INSTRUCTIONS CAREFULLY IN THE MANUAL AND THE
FOLLOWING NOTES CAREFULLY