THANK YOU!
Thank you for buying a Geni
product. For best results, please
carefully read and follow the
directions in this product user manual.
TM
Mojo Scan I
Product User Guide
MJC-1XA,MJC-1YA
Note: For simplicity, the back panel of one Mojo product is shown.
Other product back panels may differ slightly.
Mojo
A B C D
E
F
G
H
A - Earth (Ground)
B - IEC power connector
C - Fuse holder
D - DMX signal Canon connector (IN)
E - DMX signal Canon connector (OUT)
F - Microphone
G - Product specification label
H - DMX and function dip switches
Mojo Series Product Back Panel
Figure 5
Appendix B - Back Panel
Appendix A - DMX Dip Switch Value Guide
DMX products must have their own "address" to receive DMX signals.
Addresses on Mojo series products are set by flipping appropriate DMX dip
switches.
To do this, you need to know that DMX dip switches have the following values:
#1=1; #2=2; #3=4; #4=8; #5=1; #6=32; #7=64; #8=128; #9=256. And you need
to know that DMX address settings are the sum of the dip switch values.
TM
For example, standard DMX addresses for four Mojo Scan I , each of which
has four channels as Follow:
MJC-1XA,1YA Address Value
DMX Dip Switches "ON"
Unit 1
1
#1
Unit 2
4
#3
Unit 3
7
#1 & #2, #3
Unit 4
10
#2, #4
Explanation: Since each unit has four channels, each address advances four
values (See Address Value above).
Once address values are figured out, add DMX dip switch values to obtain the
appropriate address (DMX Dip Switches "ON") for each unit. Flip appropriate
DMX dip switches on each unit.
9
