4.2.
Depending on which fiber ingress port was chosen, run the patch cord
through the fiber management system in the appropriate fashion.
It is important to run the fiber as shown below in order to avoid sharp bends
that will cause signal degradation.
6
4.
Place connector and patch cord back in bracket
Insert the connector back in the Bracket and run the patch cord through the
fibre management system.
4.1.
Replace connector
Stop
: There is only one way to put the connector back in
the bracket. Make sure the silver tab (circled in red below)
is pointing towards the centre of the Bracket and the fibre
is pointing towards the top of the Bracket.
