Genevac EZ-2 Series
Unpacking and Setting Up
04-5365
page 2 of 2
Issue1-9 February 2014
Setting Up
Place the drip -plate in the moulding recess to the right
of the lid.
Fit the catch pot by screwing it into the retainer on the
side of the EZ-2.
Fit the condenser jar.
Make sure the jar is correctly aligned
Taking care to avoid dropping the vent filter inside the
EZ-2 cladding, carefully insert the vent filter into the
hole in the service panel and screw onto the threaded
connector.
Push the exhaust hose (supplied) to the spigot on top
of the exhaust catch-pot. Connect the other end of
the exhaust hose to an appropriate laboratory fume
extraction system.
Arrange the exhaust hose so it takes solvent vapours
away from the evaporator safely. Avoid forming U-
bends in the pipe as this could cause condensed
solvent to gather.
Connect the mains supply lead.
Before powering up, check all parts of the system are
installed correctly.
Genevac Ltd, The Sovereign Centre, Farthing Road, Ipswich, IP1 5AP, UK
Service: +44 (0) 1473 243000
Email:
