Basler
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
40
EN.100.007-V4.8.C3.(1)
Configuring Basler units
Complete the following configuration procedures before adding Basler units in Omnicast.
This section includes the following topics:
•
Set the encoder type for all video streams
•
Set the encoder type for all video streams
For each video stream you’ll be using, you must select the encoder type you want to use to com-
press the stream.
1
Open the unit's Web page.
2
Click
Configuration > Camera Configuration > Streaming
.
3
Click one of the video stream tabs.
4
From the
Encoder Type
drop-down list, select the desired encoder type for that stream.
NOTE
Multicast can only be used with Stream0. To use multicast with Stream0, set the
Encoder Type
to
H.264
or
MPEG-4
.
5
for each video stream you want to use.
NOTE
You can disable Stream1 and Stream2 if you are not using them. From the
Encoder
type
drop-down list, select
Off
. Only disable Stream2 if Stream1 is also disabled.
