AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016
9
Installing SharpX mobile hardware
Installing a mobile AutoVu system will allow you to read the license plates of passing vehicles.
Before you begin
Complete
.
What you should know
WARNING
:
Only AutoVu-certified personnel should setup and install AutoVu systems. Read all of
the procedures in this guide before installing an AutoVu fixed or mobile system. Failure to follow the
supplied instructions or information may result in loss of data or damage to hardware and will void
warranty.
To install SharpX mobile hardware:
1 Remove the required headliner and panels for wiring.
To ensure all parts are replaced correctly, label (for example, "front passenger side") and safely
store all panels and screws.
2
for the SharpX camera.
3
Drill holes for the camera cable
4 If using a hardmount,
attach the SharpX to the hardmount using the Universal Mounting Bracket
.
5
6 Install camera wiring.
Run the SharpX cable to the required locations for power and data.
7 Test the SharpX camera cables:
a)
b)
8
Connect the SharpX camera for a mobile installation
.
9 Install the PC docking station.
Refer to manufacturer’s installation instructions.
10 Install and configure
. This is required in order to provide precise
odometry information for AutoVu systems that include wheel imaging cameras.
11 Test the camera's live feed view to ensure that the camera is wired properly and that the
hardware is functional. For more information, refer to the
Sharp Administrator Guide
.
12
.
13 Replace the vehicle paneling that was removed during the installation.
14
using the live feed in the Sharp Portal.
15
with the required information from the installation.
Related Topics
Camera cabling do's and dont's
on page 26
