English
12" Dual-Bevel Sliding Compound Miter Saw
Operator’s Manual
GMSDB1215LF
6
•
Keep your hands out of the path of the saw blade
. If the workpiece being cut causes
your hands to be within 7-1/4” of the saw blade, the workpiece should be clamped in place before making
the cut.
•
Keep the motor air slots clean and free of chips
, dust, or other obstructions which may
impair the flow of cooling air to the motor.
•
Make sure all the saw’s adjustment handles are tight
before cutting, even if the table
is positioned in one of positive stops. Do not forget to tighten the bevel adjustment handle.
•
Never apply lubricants
to the blade when it is running.
•
Never use saw blades
rated for operation at less than 5000 RPM.
•
Never start the tool
with the workpiece against the blade.
•
Allow the motor to attain full speed
prior to starting the cut.
•
Always keep the blade guards in place
and use at all times.
•
Never reach around
or behind the saw blade.
•
Never lock the switch
in the “ON” position.
•
Never attempt to recut small pieces.
•
Never cut ferrous metals or masonry
.
This miter saw is designed to cut wood and wood-like
products.
• Do not perform free-hand cutting operations
. Hold the work firmly against the fence and
table. Use clamps to hold the work when possible.
• Long or wide workpieces should be properly supported.
•
IMPOrTANT: After completing the cut
, release the power switch and allow the blade to
come to a complete stop before returning the saw to a raised position.
•
Turn off the saw and allow the blade to completely stop
before cleaning the blade
area or removing debris and off-cuts in the path of the blade. Coasting blades are dangerous.
•
Turn off the saw and allow the blade to completely stop
before removing or un-
securing the workpiece, changing the workpiece angle, or changing the angle of the blade.
•
Never perform layout,
assembly or set-up work on the saw table or work area while the machine is
running.
•
Turn the machine “off” and disconnect the machine
from the power source before
installing or removing accessories, before adjusting or changing set-ups, or when making repairs.
•
Disconnect the machine
from the power source and clean the work area before leaving the
machine.
•
If any part of your miter saw is missing, damaged, or fails in any way,
or any
electrical component fails to perform properly, shut off the switch and remove the plug from the power
source. Replace missing, damaged, or failed parts before resuming operation.
WArNINg:
read and understand all warnings, cautions and operating
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
