English
7.2V Lithium-ion Screwdriver
Operator’s Manual GLSD72A
oPERAtion
WARning:
to reduce the risk of serious personal injuries, read and
follow all important safety warning and instructions before using this tool.
WARning:
Always place the switch in the locked or off position before
any assembly, adjustments or changing accessories
.
CHARGING THE TOOL
NOTE
:
Always Check that the power supply corresponds to the voltage on the ratings plate
.
1. Turn tool off.
2. Connect the charging adaptor to charging port
3. Plug the adaptor into a power source.
4. Battery power indicator light: ReD means the tool is charging. GReeN means the charging is
completed. The charger will automatically stop charging when the battery is fully charged.
NOTE
:
It takes 3-5 hours to charge up a completely discharged battery.
TRIGGER SWITCH ACTION
• Turn the screwdriver on by depressing the trigger switch.
• use the reversing switch to change the direction of rotation of the driver.
• The Reversing Switch has three positions: forward, Reverse, and Off (middle).
• Always check the rotation before beginning your work.
TWO SPEED GEAR SWITCH (FIG 2)
• Slide the speed gear switch to choose between position
1 for low speed 200 RPM and position 2 for high speed
range 400 RPM.
• The low speed has more power and torque. use the low
speed for high power and torque applications.
• The high speed is for fast drilling or driving applications
OVERLOAD PROTECTION
your tool is equipped with an overload protection circuit to protect the motor and battery in the event
of a stall. When the tool is stalled, it will automatically turn itself off. If this happens, remove the tool
from the work piece, turn off the tool, wait for a few seconds, then turn it on and continue using it.
Sometimes, when the battery is low, the tool may shut down automatically more often. This indicates
it is time to recharge the battery.
LED WORK LIGHT
your tool has a built-in LeD work light to illuminate the work area. When you turn on the tool, the
work light will automatically turn on.
BATTERY POWER INDICATOR (FIG 2)
your tool has a battery power indictor. It consists of a green light, yellow light, red light and push
button. To show the battery power, simply just push down the button.
If all three lights are on, the battery is fully charged.
If both red and yellow lights are on, battery is OK for operation of the tool.
If only the red light is on, it is the time to recharge the battery.
10
Fig 2
TWO SPEED
GEAR SWITCH
BATTERY POWER INDICATOR
