Genesis GenWatch3 GW RSP25, Book

Page: 14 / 30

14
600- 2.16.15 -EE.1
Updating a Connection
In most cases, after you configure a GW_RSP25 connection, you will not need to
update it. However, you can update the GW_RSP25 connection properties if you
make a data entry error or if the settings change for some reason. To update an
existing connection, take the following steps:
1. In the Connections list, select (click on) the connection that you wish to
update. This will show the properties of this connection.
2. Update the properties that you wish to change.
3. Click the Update button.
You can cancel a pending add or update and discard changes by clicking the Cancel button.
Deleting a connection
In most cases, after you add a GW_RSP25 connection, you will not need to delete
it. However, you can delete a GW_RSP25 connection if you no longer want to
monitor the connection’s packet source. To delete an existing connection, take the
following steps:
1. In the Connections list, select (click on) the connection that you wish to
delete. This will show the properties of this connection.
2. Click the Delete button. This will result in a confirmation prompt.
3. Click Yes .
Connection Properties
Each GW_RSP25 connection contains many properties. The properties are
defined in detail below.
Connection Settings
•
Connection Alias : This name will be used to reference the connection.
•
Connection Type : Used to set the input mode used by this connection.
o
Serial : When selected, the connection will use the Port Number
(COM Port) specified to connect to a data source.
o
Topaz : When selected, the connection will use the Host Name /
IP value to connect to a Topaz-enabled digital transceiver. The
Port option is not displayed and is automatically set to 9130.
o
TCP/IP: When selected, the connection will use the Host Name /
IP and Port values to connect to a TCP/IP socket.
o
TCP/IP: When selected, the connection will use the Port
Number (COM Port) specified to connect to a data source. Each
packet received is then echoed via TCP/IP on the specified Port .
o
Millennium: When selected, the connection will automatically use
the next available XTL Series Digital Transceiver connected to the
machine via USB.