5-51
05
2. On your garage door opener in your
JDUDJHORFDWHWKHŕ/HDUQŖEXWWRQ
(usually near where the hanging
antenna wire is attached to the garage
door opener). If there is difficulty
locating this button, reference the
device’s owner’s manual.
3.
3UHVVDQGUHOHDVHWKHŕ/HDUQŖEXWWRQ
4. A light on your garage door opener
may flash, and your Two-Way
Communication indicators (4), (6) in
your vehicle may flash, confirming
completion of the process.
5. Return to the vehicle and firmly
press and release the programmed
HomeLink button to activate
your garage door. The Two-Way
Communication indicators (4), (6)
flash in orange when the door is
moving. Do not make any additional
button presses until AFTER the garage
door has come to a complete stop.
6. Your Two-Way Communication
programming is now complete.
Information
If your garage door opener has Two-
:D\&RPPXQLFDWLRQIXQFWLRQDOLW\
it is possible for HomeLink to stop
functioning the garage door shortly
after initial programming, IF the Two-
:D\&RPPXQLFDWLRQ3URJUDPPLQJ
wasn’t properly completed. This
usually happens after the first 10 times
a programmed HomeLink button is
pressed. If you experience this, completing
the “Programming a New HomeLink
%XWWRQ´DQG³7ZR:D\&RPPXQLFDWLRQ
Programming” will restore door
operation.
4) Canadian Programming
Canadian radio-frequency laws require
transmitter remote signals to “time-
RXWŖRUTXLWDIWHUDFRXSOHVHFRQGVRI
transmission, which may not be long
enough for HomeLink to pick up the
signal during programming.
If you live in Canada or you are having
difficulties programming a gate operator
or garage door opener by using the
programming procedures, replace
ŕ3URJUDPPRPH/LQN%XWWRQŖ
step 3 with the following:
While the HomeLink indicator light (7)
is flashing orange, press and release
ŕF\FOHŖ\RXUGHYLFHŔVKDQGKHOGUHPRWH
every two seconds until the HomeLink
indicator light (7) changes from orange
to green. You may now release the hand-
held remote button. Then proceed with
ŕ3URJUDPPRPH/LQN%XWWRQŖ
step 4.