Picklist Mode
Parameter # F0h 92h
Picklist mode enables the decoder to decode only bar codes aligned under the center of the aiming pattern.
Select one of the following picklist modes:
•
Disabled Always
- Picklist mode is always disabled.
•
Enabled Always
- Picklist mode is always enabled.
Decode Session Timeout
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a
Decode Session Timeout
, scan the bar code below. Next, scan two numeric bar codes from
that correspond to the desired on time. Provide a leading zero for single digit
numbers. For example, to set a
Decode Session Timeout
of 0.5 seconds, scan the bar code below, then scan
the
0
and
5
bar codes. To correct an error or change the selection, scan
NOTE
With Picklist Mode enabled, the decode aiming pattern turns on even when the
is disabled.
*
Disabled Always
(00h)
Enabled Always
(02h)
Decode Session Timeout
G S -R 5000 -51C Barcode Configuration Document
