SET-UP and INSTALLATION
Install the batteries, the camera tipped probe and insert the SD card
in the monitor before using the scope.
Please follow the installation
steps listed below:
NOTE!
Dry your hands before installing or replacing batteries.
Installing the Batteries
1. Using a screwdriver, remove screw and cover from the base.
2. Remove the battery holder and insert four new “AA” batteries
into the proper slots of the battery holder.
Proper battery orientation is indicated on the battery holder.
3. Insert the battery holder into the handle and re-attach the battery
cover and the screw.
Installing the Camera Tipped Probe
In connecting the probe to the base unit, make sure the keyed ends
are properly aligned. Once they are aligned, tighten the knurled
knob to hold the connection in place.
5
FCC INFORMATION
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference. (2) this device must accept any
interference received, including interference that may cause
undesired operation. Changes or modifications not expressly
approved by the party responsible for compliance could void the
user’ s authority to operate the equipment.
CAUTIONS!
• The apparatus shall not be exposed to dripping or splashing and
that no objects filled with liquids, such as vases, shall be placed
on the apparatus. Do not expose instrument to moisture.
• Turn off the Camera/Monitor if the system is not in use.
• The adapter is used as the disconnect device from the mains. The
adapter shall remain readily operable.
• The Camera/Monitor can only be completely disconnected from
the mains by unplugging the adapter.
• Do not cut the DC power cable of the apparatus to fit with another
power source.
• Attention should be paid to the disposal of batteries in environ-
mentally-friendly ways.
• Remove the batteries when cleaning the unit.
• Remove the batteries before storing the unit for a long time.
• When necessary, replace all four batteries at the same time with
new ones.
• Use only the size and type of battery specified.
• Be sure to install the battery with the correct polarity as indicated
in the battery compartment.
16