15. Plug the dongle into any open USB port on your computer. Doing so
will cause the following screen to appear.
16. On the meter, press the
Power/Tx/Rx/Ax
button once.
TO
(the
default transmitting channel) will appear at the right of the display.
You will next change the transmitting channel number to 1. To do
so, press and hold the
Hold/CH
button. The display will show
T = 0
(with the “
0
” flashing) over
R = 0
. Quickly (within 10 seconds)
press the
Select/0-9
button once to advance the channel counter
to “1”. Quickly save the setting by pressing and holding the
Hold/CH
button.
17. On the “DMMD_PCView GTSF05” screen, click the
Scan CH
button. The program will begin scanning Channels 0 through 9.
Scanning will stop when the GT320’s transmission on Channel 1 is
detected, causing the
���
button to turn green.
18. Click again on the green
���
button to produce a display like the
following:
19. The reading on the DMMD_PCView screen will continue to
duplicate the contents of the GT320’s readout.
17
