FOR MODELS 50-220 & 50-220R
Here, the bolt holes in the T-28 (top) and T-52 rear fence rails are shown in relation to the corresponding holes in a
General International model 50-220 or 50-220R table saws. Remember that if you are using General T-fence rails with
another manufacturer’s saw, you may have to drill custom holes in your saw to fit.
T-52
Use a ruler to ensure that the top of the back rail is 7/16” lower than the
table top. Tighten the nuts on right and left sides first, then the rest.
ASSEMBLE THE FENCE LOCKING MECHANISM
1.
Install the camfoot,
, (with the top loop facing you) by inserting the
smaller pair of bolt and nut,
, through it and tightening the nut.
2.
Install the Locking handle,
, (with the black magnet facing up) by
inserting the larger pair of bolt and nut,
, through it and tightening
the nut.
Important: Do not over tighten bolts or the cam and handle will be
unable to rotate freely.
T-28
7
