En-8
To Set the Thermostat
Press the TEMPERATURE set button (Fig. 5
I
).
button:
Press to increase the thermostat setting.
button:
Press to lower the thermostat setting.
●
Thermostat setting range:
COOLING MODEL
Cooling/Drying ................. 18 to 30 °C
Fan .................................... 17 to 30 °C
HEAT & COOL
Heating ............................. 16 to 30 °C
MODEL
Cooling/Drying ................. 18 to 30 °C
About three seconds later, the entire display will reappear.
NOTE:
●
The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
●
During Fan mode, set the unit to “– –” for continuous fan operation regardless of
room temperature. [COOLING MODEL ONLY]
●
The thermostat cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the remote control unit’s display).
[HEAT & COOL MODEL (Reverse Cycle) ONLY]
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 5
L
).
Each time the button is pressed, the fan speed changes in the following order:
AUTO
HIGH
MED
LOW
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling :
Operation begins and as the room temperature approaches that of
the thermostat setting, the fan speed switches to the low setting.
Fan: [COOLING MODEL]
Fan speed is selected automatically in accordance with nearby room
temperature.
Fan: [HEAT & COOL MODEL (Reverse Cycle)]
Fan operation will alternate between low speed and off.
* Heating :
The fan operates at low speed at the beginning of operation or other-
wise when the temperature of the emitted air is relatively low; the fan
speed increases as the temperature of the emitted air rises.
However, the fan will operate at very low speed when the air issued
from the indoor unit is low (
☞
P. 7).
To Stop Operation
Press the START/STOP button.
Example:
When set to 26 °C
Example:
When set to AUTO
s
s
s
s
* During Heating mode:
Set the thermostat to a temperature set-
ting that is higher than the current room
temperature. The Heating mode will not
operate if the thermostat is set lower than
the actual room temperature.
During Cooling/Dry mode:
Set the thermostat to a temperature set-
ting that is lower than the current room
temperature. The Cooling and Dry modes
will not operate if the thermostat is set
higher than the actual room temperature
(in Cooling mode, the fan alone will oper-
ate).
During Fan mode:
You can not use the unit to heat and cool
your room.
OPERATION
9373471011_en.p65
2004/1/13, 10:54
8
www.enindel.com
Summary of Contents for AOG17UNBN
Page 2: ...www enindel com ...
Page 20: ...www enindel com ...
