INSTALL THE CONTROL BOX
3.
Tighten the bolts to secure the control box in place,
with a 10 mm open end wrench,
.
CONNECTING TO A DUST COLLECTOR
The 24" horizontal double drum sander is equipped with
two 4” diameter dust outlets,
, on top of the machine,
allowing for the connection to a dust collector
(not
included)
.
If you do not already own a dust collection system consider contacting your General® International distributor for
information on our complete line of dust collection systems and accessories or visit our Web Site at: www.general.ca.
Be sure to use appropriate sized hose and fittings
(not
included)
and check that all connections are sealed
tightly to help minimize airborne dust.
8
Note: Recommended dust collection CFM requirements for this sander is 1200 CFM (or 2HP dust collector).
1.
Loosen, but do not remove, the 2 hex bolts,
, in-
stalled on the top right hand corner of the machine.
2.
Slide the control box onto the heads of the bolts.
1
2
Do not plug in the power cord yet.
Do not operate this sander without an adequate dust collection system properly installed and running. Operating
this sander without adequate dust collection can lead to equipment malfunction or dangerous situations for the
operator or other individuals in the workshop.
