OVERLOAD PROTECTION/CIRCUIT BREAKER
1.
Set the power switch on the sander to the off posi-
tion and disconnect the machine from the
power source.
Note: If the sander is permanently connected to a cir-
cuit (hard-wired), set the wall panel circuit breaker or
main circuit interrupter to the off position.
2.
Unscrew the 2 screws
(on top and bottom of the
control box front cover) then remove the front cover
and press the blue reset button
.
3.
Reinstall the control box cover.
4.
Reconnect the sander to the power source.
5.
You can now restart the sander by pushing on the
green button ON.
SWITCH OFF
TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP BE CERTAIN THAT THE POWER SWITCH HAS BEEN SET TO THE OFF POSITION
BEFORE RE-SETTING THE CIRCUIT BREAKER.
FRONT TABLE HEIGHT ADJUSTMENT
Adjusting the height of the table allows an even wearing
of the sanding belt surface by allowing you to use diffe-
rent sections of the belt depending on the height of the
workpiece. To raise or lower the table:
1.
Loosen the two lock knobs
then turn the height
adustment knob
until the table is at the desired
height.
2.
Tighten the two lock knobs to secure the table in posi-
tion.
Tip: To maximize belt usage when working with shorter work pieces, periodically adjust the table height to system-
atically make use of various portions of the belt. For example: a series of 2” tall workpieces can be separated into
3 smaller batches with each batch being sanded with the table set at different heights to use in sequence the lower,
middle or upper portion of the belt.
12
ON/OFF MAGNETIC POWER SWITCH
This model 15-010 M1 is equipped with a Magnetic 2-step
safety switch to prevent unwanted or unintentional start-up
and unauthorized use of the saw. The switch assembly is
equipped with a GREEN “START” button
A
, an extra-large
easy access RED stop panel
B
, and a lock-out key
C
.
To start the molder
: Insert the lock-out key
C
and press on
the GREEN “START” button
A
.
To stop the molder
: Press on the RED “STOP” panel,
B
. Once
the RED “STOP” panel has been pressed, the saw can only
be started by pressing once again on the RED “STOP” panel
to release the green button, then by pressing on the green
button.
B
A
C
The magnetic safety switch on this sander is equipped with an overload protection feature. To prevent an electrical
overload from damaging the motor, in the event of a spike in line voltage or amperage draw, the internal overload
protector will automatically be tripped, thereby cutting off power to the motor.
To reset the overload protection switch after it has been tripped proceed as follows:
Summary of Contents for 15-010 M1
Page 21: ...Notes 21...