General 10-300, Setup & Operation Manual, Page: 4 / 16

WET / DRY VACUUM CLEANER
10-300 / 10-315
IDENTIFICATION OF PARTS & COMPONENTS
POWER CORD/PLUG
110 Volt A.C. To prevent damage
to the power cord, to not unplug
by pulling on the power cord -
always handle by the plug.
FRONT CASTERS
& REAR FIXED WHEELS
10 GAL. TANK
MODEL 10-300
POWER SWITCH
Sealed, water resistant three position
switch: Low – Off – High.
FILTER BAG
Designed to keep dust in the
canister and away from the
motor.
POWER CORD/PLUG
110 Volt A.C. To prevent damage
to the power cord, to not unplug
by pulling on the power cord -
always handle by the plug.
FRONT CASTERS
& REAR FIXED WHEELS
LIFTING HANDLES
On each side of the tank.
15 GAL. TANK
HOSE INLET
MODEL 10-315
POWER SWITCH
Sealed, water resistant switch: On /Off.
FILTER BAG
Designed to keep dust in the
canister and away from the
motor.
PLEATED INNER FILTER CARTRIDGE
Should be removed for wet vacu-
uming. Provides secondary dust
filtration up to 3 microns.
4
ACCESSORY STORAGE RACK
AIRFLOW INDICATOR
When the unit is turned on the
airflow indicator will pop up
indicating that air is flowing
through unrestricted and the
unit is functioning properly. If
the airflow indicator does not
pop up, there may be an
obstruction or the tank may be
full: in this case, stop the unit
and check or empty the unit
as necessary.
HOSE INLET
ACCESSORY
STORAGE
RACK
LIFTING HANDLES
On each side of the tank.
PLEATED INNER FILTER CARTRIDGE
Should be removed for wet vacu-
uming. Provides secondary dust
filtration up to 3 microns.
LID CLAMPS
Secure the lid to
the tank creating
an airtight seal.
LID CLAMPS
Secure the lid to
the tank creating
an airtight seal.