General 10-110, Operation Manual

Page: 10 / 18

10
Attach the collector bag by using the hooks on the unit
to hold it in place D . Use the belt clamp to attach the
bag to the lower portion of the drum E . Before tighten-
ing the clamp, make sure the metal strap is sitting in the
groove on the lower portion of the drum to create an
airtight seal between the drum and the bag.
If you have model 10-110CF (with canister filter) skip
ahead to step #9.
Fit the upper bag support into the holes on the drum
F
. Slip a belt clamp through the opening in the filter
bag until it comes out through the hole at the other
end
G
. Use the belt clamp to attach the filter bag to
the upper portion of the drum
H
. Before tightening
the clamp make sure the metal strap is sitting in the
groove on the upper portion of the drum to create an
airtight seal between the drum and the bag.
USE CAUTION AND WEAR GLOVES WHEN HANDLING
METAL PARTS SUCH AS BELT CLAMPS, WHICH CAN CUT
IF HANDLED CARELESSLY.
Basic assembly is now complete and your dust col-
lector is ready to be put into service. Once the unit is
hooked up to an appropriate electrical connection,
turn on the unit and check for air leaks around the
bags or canister filter
(model 10-110CF)
. If there is an air
leak, peel off the backing of the adhesive foam gasket
and stick it onto the drum, making sure the gasket is
sitting in the appropriate groove.
STEP 10 - INSTALL THE FOAM GASKET
(IF NEEDED)
If you have model 10-110 with filter bag skip ahead to step
#10.
Fit the canister filter onto the drum as shown and use
the belt clamp to hold the canister securely onto the
drum.
Tip/Hint: To seat the canister on the rim of the drum, run a
flat piece of wood (such as a ruler) between the drum and
the black apron on the bottom of the canister I.
STEP 9 - FIT THE CANISTER FILTER ONTO THE DRUM
(#10-110CF ONLY)
D
STEP 7 - INSTALL THE COLLECTOR BAG
E
STEP 8 - INSTALL THE FILTER BAG ON THE DRUM
( #10-110 only)
F
G
H
I