General International DP2002, Setup & Operation Manual, Page: 11 / 44

11
170207
ENGLISH
factors that cannot be built into this product, but must be supplied by the
operator.
LASER SAFETY
This tool is equipped with a patented precision cross-pattern laser
alignment and centering guide.
1. DO NOT STARE DIRECTLY AT THE LASER BEAM.
DANGER!
Eye damage may occur if you deliberately stare
into the beam.
2. THE LASER LIGHT BEAM
used in this system is Class II with maximum 1 mW and 650 nm
wavelengths. AVOID DIRECT EYE EXPOSURE.
3. THE LASER MUST BE USED AND MAINTAINED IN
ACCORDANCE WITH THE MANUFACTURER’S INSTRUCTIONS:
• Never aim the beam at any person or an object other than the
workpiece.
• Do not project the laser beam into the eyes of others.
• Always ensure the laser beam is aimed at a workpiece without
reflective surfaces as the laser beam could be reflected into your
eyes or the eyes of others.
UNPACKING
WARNING!
Do not attempt to assemble the tool, plug in the power
cord or turn on the switch if any parts are damaged or missing. Failure to
heed this warning could result in serious personal injury.
CONTENTS
Separate all parts from the packing materials and check carefully against
fig. 2 and the list below.
NOTE: Make certain all parts are accounted for before discarding any
packing material.
Some items below may be packed already assembled to each other.
A Head assembly
B Table support lock handle
C Column
D Base
ee AA batteries
F Hex head bolt (4 pcs.)
G Crank handle
H Table assembly
I Worm shaft
J Chuck guard
K 1/2" Chuck
L Chuck key
M Feed handles (3 pcs.)
ii 2 hex keys (3 mm & 4 mm)
L
I
ii
K
M
H
J
ee
F
G
B
C
D
fig 2
A