12
1.
Lower the head to its maximum
.
2.
Place a piece of taller stock (minimum 3”) against
the fence
.
NOTE: Make sure you are using a piece of planed and
squared stock that has an even thickness.
3.
Loosen the fence locking levers
and slowly
advance the fence with the piece of wood towards
the chisel.
TO SQUARE THE CHISEL TO THE FENCE
If the face of the chisel sits flush against the stock
the
chisel is square. Tighten the chisel locking lever and
proceed with normal operation.
If the chisel does not sit flush:
1.
Loosen the chisel lock lever
and manually turn
the chisel
until its face sits flush against the stock.
2.
Lock the lever to secure the chisel in position.
BASIC ADJUSTMENTS & CONTROLS
CONNECTING TO A POWER SOURCE
SWITCH OFF
TO REDUCE THE RISK OF SHOCK OR FIRE DO NOT OPERATE THE UNIT WITH A DAMAGED POWER CORD OR PLUG.
REPLACE DAMAGED CORD OR PLUG IMMEDIATELY.
TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP, MAKE SURE THAT THE POWER SWITCH IS IN THE OFF POSI-
TION BEFORE CONNECTING TO A POWER SOURCE.
Once the assembly steps have been completed and
the unit is safely secured to a work surface, uncoil the
power cord and plug the power cord into an appropri-
ate outlet. Refer back to the section entitled “ELECTRI-
CAL REQUIREMENTS” and make sure all requirements
and grounding instructions are followed. When mortis-
ing operations have been completed unplug the mor-
tiser from the power source.
Summary of Contents for 75-050T M1
Page 21: ...21 Notes ...
