17
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
ADJUSTING THE SAW HEAD STOPS
1.
If the downfeed handle is difficult to reach in the
up position, loosen jam nut
B
with a 19 mm wrench,
then loosen bolt
C
until the desired handle height is
reached. Retighten jam nut
B
.
2.
To adjust the saw head in the down position, loosen
jam nut
D
with a 19 mm wrench, then turn bolt
E
clockwise or counterclockwise as per the adjust-
ment desired. Retighten jam nut
D
.
F
IMMOBILIZING THE MACHINE
Machine vibration during operation may cause the
machine to move, particularly when installed on un-
even surfaces.
The bolt-down tabs and anchor bolts
F
can be used to
help keep the machine immobilized by either lower-
ing the bolts against the floor to act as another point of
contact with the floor, or for permanent installations, by
drilling into the floor and bolting the machine in place.
3.
To adjust the vise jaw, loosen screw
A
with a 10 mm
Allen key. Slide the jaw right or left to the desired
position, then retighten screw
A
.
Note: Adjustment required for miter cuts.
Note: Pull back the vise assembly to allow the rotation of
the saw head all way to the right, especially for miter cuts.
ADJUSTING AND USING THE VISE (CONTINUED)
A
D
E
B
C
