ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE MAKING ANY ADJUSTMENTS. FAILURE
TO HEED THIS WARNING CAN LEAD TO SERIOUS PERSONAL INJURY.
KNIVES ARE VERY SHARP. USE CARE WHEN HANDLING KNIVES.
C
C
C
3.
Turn the upper pulley
D
by hand, until any one of
the knives is at it’s lowest point.
1.
Make sure that the the machine is disconnected from
the power source.
2.
To give yourself unimpeded access to the cutter head
and knives, remove the top cover
B
, by loosening and
removing the 3 screws
C
.
D
B
4.
Place your gauge block onto the table, under one
extremity of the cutter head as shown in
E
and
F
.
UP
DOWN
5.
Loosen the cutter head lock lever
G
by turning it
counterclockwise, then lower or raise the cutter
head as needed until the knife lightly touches the
top of the gauge block as shown in
H
when you
manually rock the cutter head back and forth.
6.
Tighten the cutter head lock lever
G
to secure the
cutter head in position.
F
H
E
G
7.
Place your gauge block onto the table, under the
other extremity of the cutter head to check for knife
parallelism with the table.
Should the knife not be set properly follow next steps. If
the knife is parallel to the table, skip ahead to step
15
.
SETTING ONE KNIFE PARALLEL TO THE TABLE
14
8.
Turn the upper pulley by hand until you can fit the
supplied T-handle wrench into the holes in the cut-
ter head shaft as shown in
I
and
J
to keep the
cutter head from turning.
UNDERSIDE VIEW
I
J