The unit is equipped with a circuit breaker
A
to protect the motor from power surges or spikes in line voltage. In the
event of a power surge, the circuit breaker will be automatically tripped thereby cutting off the power to the motor.
Note: If your machine’s motor was converted from 220 V to 110 V power, circuit breaker
B
will be tripped if a power surge
occurs.
OVERLOAD PROTECTION/CIRCUIT BREAKER
To reset the circuit breaker after it has been tripped; set the power switch to the “off” position and depress
the reset button,
A
or
B
, then restart the machine.
TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP BE CERTAIN THAT THE POWER SWITCH HAS BEEN SET TO
THE OFF POSITION BEFORE RE-SETTING THE CIRCUIT BREAKER.
B
A
B
A
MODEL 15-035DC
MODEL 15-035
To tilt the sanding belt table
1.
Loosen table locking handle
A
.
2.
Tilt the table to the desired angle, as indicated on the
bevel scale
B
. Turn the lock knob clockwise to secure
the table in position.
To tilt the sanding disc table
1.
Loosen table locking handles
C
.
2.
Tilt the table to the desired angle, as indicated on the bevel scale
D
. Turn the lock knobs clockwise to secure the
table in position.
TILTING THE SANDING BELT/DISC TABLE
BEFORE MAKING ANY ADJUSTMENTS, MAKE SURE THAT
THE SWITCH IS IN THE “OFF” POSITION AND THAT THE
POWER CORD IS UNPLUGGED
REAR VIEW
C
B
A
C
D
HORIZONTAL/VERTICAL SANDING BELT ADJUSTMENT
To change the sanding belt from vertical to horizontal position.
1.
Make sure the sander is turned off and unplugged.
2.
Using a 10 mm wrench and the supplied 3 mm allen key, loosen
lock nut
A
, then set screw
B
.
3.
Set the sanding head to the horizontal position.
3.
Re-tighten set screw
B
and lock nut
A
to secure the sanding
head in position.
A
B
Note: Belt tracking adjustments may be necessary after changing
the position of the sanding head from vertical to horizontal position.
(See “Sanding belt tracking adjustment instructions below)
16
Summary of Contents for 15-035 MI
Page 27: ...Notes 27...
