General DataComm SpectraComm 800 T3, Installation & Operation Manual

Page: 44 / 62

SC800 T3 Operation SC800 T3 Maintenance Screen
3-18 SpectraComm 800 T3 Data Service Unit 076R160-000
Installation and Operation Manual Issue 4
SC800 T3 Maintenance Screen
At the SC800 T3 Main Menu, press
4
and then press
Enter
to access the Maintenance screen,
shown below. Table 3-9 describes the maintenance commands on this screen. Table 3-10 describes
the Firmware Download submenu.
Note
!IMPORTANT! Commanding the DSU to either [2] Soft Reset or [3] Set to Factory Defaults will disrupt
communications.
Table 3-9 Maintenance Selections
Selection Description
[1] What Are You Read-only display of the serial number, firmware revision, boot code
revision, and the type of shelf the DSU is installed in.
[2] Soft Reset Causes the DSU to perform a reset and resume operation using its
current configuration. Type [Y]es at the Confirmation prompt to
proceed.
[3] Set to Factory Defaults Causes all options in the DSU to return to their factory default settings.
Type [Y]es at the Confirmation prompt to proceed.
[4] Reset Statistics Advances to the Reset Statistics Selections screen, described below.
[5] Firmware Download Advances to the Firmware Download screen, described below.
[0] Return to Main Menu Exits the Maintenance menu and returns to the Main Menu.