![background image](http://html1.mh-extra.com/html/general-datacomm/sc-adt-16-por/sc-adt-16-por_installation-and-operation-manual_2210292044.webp)
SC-ADT Configuration
Telnet/SSH Management Overview
3-6
SpectraComm ADT
076R172-000
Installation and Operation Manual
Issue 6
Telnet/SSH Menu Procedure
For this procedure, the SC-ADT must be configured as described in
.
1. Start a Telnet or SSH session by defining either of the the following connection parameters as
required:
telnet
[SC-ADT IP address] or
ssh
[SC-ADT IP address]
2. Login to the SC-ADT with a valid username and password. If necessary, override any other
Telnet CLI session in progress as instructed by the screen prompt.
3. Enable supervisor privileges by typing:
enable
[supervisor-level password]
4. A successful Telnet/SSH connection to the SC-ADT will display the Telnet menu, similar to
the example shown in
.
•
Ports displayed with an asterisk (
*
) indicate another CLI user is accessing the device at
that port.
•
Ports not displayed (such as Port8 and Port9 in the example below) are not enabled or
have been configured for Transport mode.
Figure 3-1
Telnet/SSH Menu Selections (Shown SC-ADT-16 Port Device)
5. At the menu prompt, the following options are allowed:
•
select option
0
to access the SC-ADT command line interface.
Connect to a port by typing:
connect term-port p
(1, 2, ...n)
Use
^^^
as the escape sequence to return to the SC-ADT command line prompt.
•
select option
X
to disconnect the Telnet/SSH session.
•
select the desired port number to access any enabled and available port.
When finished, disconnect the session or exit the Telnet/SSH client.
Configured Terminal Server Ports ("*" by part number means port in use)
SNMP sysName: YOUR SYSTEM NAME system prompt: ADT-16pubs
------------------------------------------------------------------------------
1* SCIP-T1
2 SCES 18-port switch
3 Controller #1
4 Controller #2
5 Craft device A
6 Craft device B
7 Craft device C
10 Craft device D
11
12
13
14
15
16
------------------------------------------------------------------------------
Enter 0 for Command Line Interface (Console)
Enter X to exit
------------------------------------------------------------------------------
Select: