6. SETTING WATER HEAT MODE
7. START AND STOP HEATER
8. SETTING SCHEDULED OPERATION
9. SETTINGS
Using
[<]
and
[>]
keys, navigate
to water tank icon and press
[Enter]
.
In the following menu select one
of the following modes:
GAS
LPG or Diesel only
MIX 1
electrical 900 W+GAS
MIX 2
electrical 1800 W+GAS
EL 1
electrical only, 900 W
EL 2
electrical only, 1800 W
Using
[<]
and
[>]
keys, navigate
to
Stopwatch Icon
and press
[Enter]
Note: for best heating performance, always set MIX2.
Note: MIX1, MIX2, EL1 and EL2 only work when RV is
connected to 120V/240V service.
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
Start Time
.
The program is now set
.
To shutdown the heater at any
moment, press and hold [Enter]
button for more than 3 seconds.
Press and hold [Enter] button for 3 seconds to start the
heater back up again.
Note: it may take up to two minutes for the heater to
cool off and stop completely.
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
End Time
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
Room Temperature
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
Water Temperature
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
Water Heat Mode
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
Fan Speed
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enable (or disable) the program.
While in main menu, using
[<]
and
[>]
keys, navigate to
Wrench Icon
and press
[Enter]
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
Offset
.
Offset allows you to calibrate the remote temperature
sensor reading to ±5 degrees of its actual value.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
Time Format
(12H or Military)
.
In the following screen, using
[<]
and
[>]
and
[Enter]
keys, enter the
desired
LCD Brightness
Between 0 and 10
.
Index screen allows you to check
software version of the timer and
heater controller.
FUEL
option of the menu allows
you to prime the fuel line after the
installation or after you ran out of
fuel.
You can set the priming duration
of up to 90 seconds. Press return
at any time to stop priming.
