1. DISPLAY LAYOUT
2. POWER UP
3. SETTING TIME
4. SETTING INDOOR AIRFLOW AND
TEMPERATURE
Setting higher fan speed will increase amount of produced
heat and will heat room faster, setting lower fan speed will
decrease amount of heat.
Press
[Enter]
to go save and go back to main menu.
5. SETTING WATER TEMPERATURE
Press the rotary pushbutton
[Enter]
to bring up the menu.
First icon begins to flash
Rotate the button
[<]
and
[>]
to select the clock icon
and press
[Enter]
.
To adjust the fan speed scroll to
the fan icon and press
[Enter]
.
Select desired volume:
[VENT], [ECO], [LOW], [HIGH],
[BOOST] or [OFF] and press
[Enter]
1 – Status bar; 2 – Settings bar; 3 – Time display;
4 – Menu bar; 5 – AC line icon; 6 – Temp. display;
7 – Return button; 8 – Rotary pushbutton.
Rotate the knob to select the temperature (between 5°C
and 30 °C) or OFF, then press
[Enter]
.
Using
[<]
and
[>]
keys,
navigate to
Thermometer
Icon
and press
[Enter]
.
OFF
Water heater is turned off.
ECO
Temperature target is 40°C/104°F
HOT
Temperature target is 60°C / 140°F
BOOST
Only heats the water for 40 minutes or until
the water temperature reaches 60°C / 140°F.
QUICK START
GUIDE
COMBI-HEATER
CONTROLLER
After device is turned ON, an “INIT..” message should
appear on the screen. Few seconds later it changes to
time display.
3
4
1
6
7
5
8
2
Navigation through the menus and value adjustments
are all done by the means of rotary pushbutton (8) and
return button (7) on the front panel of the controller.
Pressing rotary pushbutton is equal to [Enter]
command, rotating pushbutton is equal to [+]/[-],
up/down or left/right..
Rotate the button
[<]
and
[>]
to enter the time. Press
[Enter]
to navigate between
segments.
Press the rotary pushbutton
[Enter]
to bring up the menu
and rotate the knob to navigate
to RV icon, then press
[Enter]
First icon begins to flash.
Flame icon will appear in the top left corner to indicate
that the heating cycle has started. The heating cycle will
continue until the setpoint was reached.
Press [Return] button to return to main menu.
NOTE:
Setting higher setpoint will not increase amount
of produced heat, use fan speed instead.
