Owner’s Manual for Generator
23
Operation
Emergency Stop Switch
The unit is equipped with one emergency stop switch.
For location of the emergency stop switch, see
. The red button is clearly labeled
“EMERGENCY STOP.” The switch can be accessed and
activated with all doors closed and locked.
Figure 3-8. Emergency Stop Switch
Activate the emergency stop switch by pushing the
button in until it locks down. This will trip the main circuit
breaker which will open the contact, disconnecting the
load to the connection lugs. This will also open the fuel
circuit, shutting down the engine. The emergency stop
fault will be displayed on the control panel. The switch
will remain closed until it is pulled out.
ECU Override Switch
The ECU override switch is located inside the control
box. This toggle switch powers up the ECU without
having to start the engine. Use the ECU override switch
to turn the ECU off. If the unit needs to be shut down
immediately, use the emergency stop switch. See
for additional information.
Figure 3-9. ECU Override Switch
Towing the Unit
Once the engine is shut down, follow these steps to
prepare the unit for towing.
1.
Verify the unit is OFF.
2.
Use the tongue jack to raise or lower the trailer
onto the hitch of the towing vehicle. Lock the hitch
coupling and attach the safety chains or cables to
the vehicle. Release the jack locking pin and rotate
the jack into the travel position. Verify the locking
pin snaps into place.
NOTE:
A film of grease on the coupler will extend
coupler life and eliminate squeaking. Wipe the coupler
clean and apply fresh grease each time the unit is towed.
3.
To ensure proper operation of the jacks, lube the
grease fittings located on the leveling jacks. See
For maintenance interval
.
4.
Connect trailer wiring to the tow vehicle. Check for
proper operation of the directional and brake lights.
5.
Verify all doors and hoods are properly latched.
6.
Check for proper inflation of the trailer tires. Proper
inflation is specified on each tire.
7.
Check the wheel lugs. Tighten or replace any lugs
that are loose or missing. If a tire has been
removed for axle service or replaced, tighten the
lugs, in the order shown, to the following
specifications:
WARNING
In case of an emergency, press the
emergency stop button to stop the engine
immediately. Failure to do so could result
in death or serious injury.
(000298)
CAUTION
(000246)
Equipment Damage. The emergency stop switch
is not to be used to power down the unit under
normal operating circumstances. Doing so will
result in equipment damage.
EMERGENCY
STO
P
002815
CAUTION
(000305)
Equipment Damage. Do not start the engine
with the Engine Control Unit (ECU) override
switch ON. Doing so will damage the ECU.
a.
Start all lug nuts by hand.
b.
First pass tighten to 20-25 ft-lbs
(27-33 Nm).
c.
Second pass tighten to 50-60 ft-lbs
(67-81 Nm).
d.
Third pass tighten to 90-120 ft-lbs
(122-162 Nm).
002816