Owner’s Manual for Indirect Fired Heater
21
Maintenance
1.
Connect red battery cable from starter contactor to
positive (POS or +) battery post.
2.
Connect black battery cable to negative (NEG or -)
battery post.
3.
Other Maintenance Checks
The following inspections should be performed by an
authorized service technician, or a properly trained auth-
orized operator. These maintenance items require a high
level of experience and skill to evaluate and correct.
•
Inspect engine accessory drive belts.
•
Inspect hoses and connections.
•
Inspect fuel supply system.
•
Inspect exhaust system.
•
Inspect exhaust pipe sleeve.
Short Term Storage
When the machine will not be in use for three or more
months, follow the guidelines below to properly store the
machine:
•
Perform all necessary maintenance or repairs
based on the
If neces-
sary maintenance is upcoming, perform the main-
tenance action before storing.
•
Fill the fuel tank to FULL.
•
Fill coolant to FULL. Do not drain.
•
Remove all dirt and debris from inside and outside
the enclosure.
•
Lock the machine to prevent any unauthorized
operation.
•
Store in a safe location — do not position near or
on top of any combustible materials; observe any
local, state, or national codes or regulations. Store
in a low moisture, low dust area.
•
Disconnect the negative cable from the battery.
Return to Service
Follow the guidelines below for engines and machines
that have not been operated for three to six months:
•
Conduct a thorough inspection of the machine
before starting the engine.
•
Verify the maintenance schedule is up to date.
•
Check all fluids for signs of fouling or degradation.
•
After starting the engine, let it warm up for more
than 10 minutes at idle.
NOTE:
Do not start or operate a machine in need of
repair or maintenance. Perform all maintenance tasks
and repairs before starting. Contact a GMP ASD if there
is any doubt as to the machine’s usability.
(000167)
CAUTION
Do not make battery connections in reverse.
Doing so will result in equipment damage.
